Filter
Top Products
Rev. D
Multi Pro 5700--D Hydraulic SystemPage 4 -- 25
Adjustments
Adjust Traction Pedal for Neutral (Machines with Serial Numbers Below 310000000)
The piston (traction) pump control lever should return to
the neutral position when the traction pedal is released.
If the machine creeps when in neutral, check the follow-
ing items:
1. The centering arms should be parallel to each other
and also parallel to the centerline of the machine.
2. The centering arms should touch both front and rear
bearings on control plate.
3. The centering arms should be tensioned by two
springs.
4. The bearings attached to control plate should rotate
freely.
Reposition the control plate on the piston pump control
lever if needed.
1. Centering arm
2. Bearing
3. Spring
4. Control plate
Figure 24
1
4
3
2
Adjust Traction Pedal for Neutral (Machines with Serial Numbers Above 310000000)
The piston (traction) pump control lever should return to
the neutral position when the traction pedal is released.
If themachine creeps when in neutral,adjust the traction
pedal neutral assembly (Fig. 25).
1. Loosen jam nut on spring shaft.
2. Adjust spring shaft until neutral operation is correct.
3. Tighten jam nut to secure adjustment.
1. Traction pedal
2. Rod end
3. Jam nut
4. Spring shaft
Figure 25
2
1
3
4
Hydraulic
System