Filter
Top Products
Multi Pro 5700–D
Page 6 – 36
Spray System
Turret Bodies
1. Turret body (w/90
o
elbow)
2. 90
o
elbow (1 used)
3. Screw
4. Turret body (w/double hose barb)
5. Turret body (w/single hose barb)
6. Single hose barb (3 used)
7. Double hose barb(7 used)
8. Turret body clamp
9. Hose barb (for 90
o
elbow)
Figure 35
7
2
8
3
9
4
5
RIGHT
6
1
BOOM
SUPPLY
CENTER
BOOM
SUPPLY
LEFT
BOOM
SUPPLY
5
4
4
4
5
5
4
4
4
4
1
3
3
Removal (Fig. 35)
IMPORTANT: Make sure to remove and neutralize
chemicals from spray components before disas-
sembly. Wear protective clothing, chemical resist-
ant gloves, and eye protection during repair.
1. Park machine on a level surface, stop engine, en-
gage parking brake, and remove key from the ignition
switch.
2. Loosen hose clamps and remove supply hose(s)
from turret body.
3. Remove screw that secures turret body clamp to
spray boom. Separate clamp halves and remove turret
body from machine.
Installation (Fig. 35)
NOTE: The type of hose barb on turret body deter-
mines turret location on spray boom. Refer to Figure 35
for turret position on booms.
1. Position turret body clamp halves to spray boom and
turret body. Slide clamp halves together. Position turret
so that spray nozzle and nozzle fan slot are parallel to
ground. Tighten clamp screw to secure turret body.
2. Install supply hose(s) to turret body. Tighten hose
clamp(s).