Filter
Top Products
Disassembly (Fig. 38)
1. Park machine on a level surface, lower booms, stop
engine, engage parking brake, and remove key from the
ignition switch.
2. Support boom to prevent it from falling. Remove cap
screw and hex nut that secure boom support to break
-
away assembly.
3. Remove hex nut, flat washer, and carriage screw
that secure support bracket to breakaway pivot. Slide
support bracket from breakaway assembly.
CAUTION
Spring in breakaway pivot is under tension. To
prevent possible personal injury, compress
spring before removing roll pin. Wear eye
protection when removing roll pin.
4. Compress spring in breakaway assembly slightly.
Drive roll pin from hinge (Fig. 40). Remove flat washer
and spring from assembly.
5. Complete disassembly as required using Figures 38
and 39 as guides.
Assembly (Fig. 38)
1. Assemble breakaway pivot using Figures 38 and 39
as guides.
2. Lubricate grease fitting on breakaway pivot after as-
sembly is complete (see Operator’s Manual).
2
1
3
4
Figure 39
1. Breakaway pivot 3. Boom support
2. Support bracket 4. Boom extension pipe
1
2
Figure 40
1. Roll pin 2. Spring
Spray
System
Multi Pro 5700–D
Page 6 – 39
Spray System