Filter
Top Products
Multi Pro 5700--DPage 7.1 -- 18Sonic Boom System (Optional Kit)
Diagnostic Display
Inputs
Diagnostic Display
LED Operation
AUTO MODE Sonic mode switch in auto position: LED ON
Sonic mode switch not in auto position: LED OFF
L RAISE Left boom actuator switch in raise position: LED ON
Left boom actuator switch not in raise position: LED OFF
LLOWER Left boom actuator switch in lower position: LED ON
Left boom actuator switch not in lower position: LED OFF
R RAISE Right boom actuator switch in raise position: LED ON
Right boom actuator switch not in raise position: LED OFF
RLOWER Right boom actuator switch in lower position: LED ON
Right boom actuator switch not in lower position: LED OFF
LNOSNSRDATA ECU has detected an invalid reading from left sensor: LED ON
Left sensor operating normally: LED OFF
L NOT TRACKING Left boom not tracking to target within 5 seconds: LED ON
Left sensor operating normally: LED OFF
RNOSNSRDATA ECU has detected an invalid reading from right sensor: LED ON
Right sensor operating normally: LED OFF
R NOT TRACKING Right boom not tracking to target within 5 seconds: LED ON
Right sensor operating normally: LED OFF
L -- SNSR FEEDBACK ECU receiving signal from left sensor: LED ON
ECU not receiving signal from left sensor: LED OFF
R -- SNSR FEEDBACK ECU receiving signal from right sensor: LED ON
ECU not receiving signal from right sensor: LED OFF
NOTE: When the vehicle ignition switch is in the OFF
position, all Diagnostic Display LED’s should be OFF.
NOTE: Initial calibration of the Sonic Boom sensors is
required for proper operation of ECU inputs. Refer to
your Sonic Boom Kit Installation Instructions for infor-
mation on initial sensor calibration.
NOTE: Right and left side Sonic Boom sensors are
identical so they can be exchanged to assist in trouble-
shooting. If a problem follows the exchanged sensor, an
electrical problem likely exists with the sensor. If the
problem remains unchanged, something other than the
sensor is the problem source (e.g. switch, circuit wiring).