Filter
Top Products
Adjustment
1. Loosen end nut that secures adjustable clevis to
boom frame (Fig. 45). Position jam nut as close as pos
-
sible to adjustable clevis. Tighten end nut to secure cle-
vis.
2. Fully raise side boom with the boom actuator. The
boom actuator should fully extend and ratchet.
3. With the boom actuator at full extension, there
should be a gap of approximately .105” (2.7 mm) be
-
tween the breakaway pivot gusset and the center boom
frame slot (Fig. 46).
4
3
2
1
4. If needed, loosen end nut that secures adjustable
Figure 45
1. Boom actuator 3. Jam nut
clevis and readjust jam nut on clevis to allow correct
4. End nut
boom actuator extension. Tighten end nut to secure cle-
2. Adjustable clevis
vis adjustment.
3
2
1
Figure 46
1. Breakaway pivot gusset 3. Boom actuator
2. Boom frame slot
Multi Pro 5700–D
Page 6 – 43
Rev. A
Spray System
Spray
System