Filter
Top Products
Multi Pro 5700–D
Page 5 – 11
Electrical System
Brake Pedal Switch
The brake pedal switch is mounted on the frame under
the floorboard (Fig. 15). The brake pedal switch pre-
vents the cruise control coil from being energized when
the brake pedal is pushed.
Testing
1. Make sure ignition switch is off. Locate switch and
unplug wire harness connector from switch.
2. When the switch plunger is pressed (brake pedal re-
leased), there should be continuity between the switch
terminals. When the switch plunger is extended (brake
pedal depressed), there should be no continuity be-
tween the switch terminals.
3. Reconnect the harness connector to the switch after
testing.
1. Brake pedal
2. Brake pedal switch
3. Washer head screw
4. Lock washer
5. Hex nut
Figure 15
1
2
3
4
5
1. Switch plunger 2. Switch terminal
Figure 16
2
1
2
Electrical
System