Filter
Top Products
124
of the sound that precedes the actual start of recording
will also be recorded.
This is not valid at the beginning of the song. Also, if
you use trigger recording to continue recording after the
end of a previously-recorded track, a PreTrigTime set-
ting other than “000 ms” will cause the corresponding
length of the previously-recorded sound to be lost.
Here you can switch the Scrub, Play From/Play To, and
Slow Play functions on/off.
The setting will alternate between On/Off each time you
press the [SCRUB] key.
By using these functions, you can set Locate or Mark times
easily and precisely while viewing the waveform.
The following functions will be available when the [SCRUB]
key is on (LED lit).
• Scrub function: Turn the [VALUE] dial to play back the
track data.
Use this to find a specific location in the song while you
listen to the sound. This method is similar to manually
rotating an analog record on a turntable while you listen
to the sound to find a desired location.
• Play From function: When you press the [PLAY] key,
playback will begin from the location at which you are
currently stopped, and will continue for two seconds.
Then playback will stop, and you will return to the loca-
tion at which playback began.
• Play To function: When you hold down the [STOP] key
and press the [PLAY] key, playback will begin from a
location two seconds earlier than where you are cur-
rently stopped, and will continue to that location.
By using the Play From function in conjunction with the
Play To function, you can find a time location with
greater accuracy.
• Slow Play function: When you press the [FF] key, half-
speed playback will begin from the location at which
you are currently stopped. Press the [STOP] key to stop
playback and return to the previous location.
The sound will play slowly, at a pitch one octave lower
than normal. You can use this function by itself or in
conjunction with a pitch shifter to learn difficult or rap-
idly-played phrases.
When this is “On,” the [VALUE] dial is used only for
Scrub playback, and cannot be used to set parameter
values.
1. Loc (Locate)................................ [000:00.000...]
Changes the current time location.
You can turn the [VALUE] dial to move the location
while listening to the sound and viewing the waveform.
2. TrackSelect.........................................[Trk1...12]
Selects the track that will be played and whose wave-
form will be displayed.
You can also press the “ ” button and choose from the
list.
3. Zoom In/Out/Up/Down
Adjusts the size of the waveform display and the play-
back speed:
: Expands the waveform display vertically.
: Shrinks the waveform display vertically.
: Expands the waveform display horizontally.
: Shrinks the waveform display horizontally.
SCRUB
1
3
2