Filter
Top Products
Operation
47
Song and Locate
MixerEffects
Modeling mode
Rhythm
The Recorder
MasteringDataDriveUSBMIDIUpgrading
the system
If you want to edit the effect in greater detail and save it
1 Edit the effect in Modeling mode (→p.45).
2 Access the [INSERT] “InsEff1” tab page.
The [MODELING] key will go dark.
The display will show the insert effect program that you
had been editing as a modeling effect.
3 Edit the settings as an insert effect, and save.
Refer to “To edit an effect” (→p.43) and “To save the
effect program” (→p.44).
For details on using an effect program that you saved,
refer to “1. Using insert effects” (→p.42).
To exit Modeling mode
To exit Modeling mode, press the [NO/CANCEL] key
several times to make the [MODELING] key go dark.
To restore the factory settings
Press the “ ” button, and the selected modeling effect
will return to the factory settings.
5. Operation in Modeling mode
Limitations in Modeling mode
• Only the [INPUT 1] or [GUITAR IN] jacks can be
used.
• The [INPUT/OUTPUT/SOLO] “Ch1–6” and “Ch7–
12” tab pages will be displayed as follows, and you
cannot make Input settings in Modeling mode.
•A maximum of two tracks can be recorded simulta-
neously.
• If you play back a scene or switch scenes while in
Modeling mode, the insert effect settings registered
in that scene will not be reflected.
•You cannot set [TRACK STATUS] to INPUT (orange).
5-1. Internal operation in Modeling mode
In Modeling mode, various functions will be set automatical-
ly in the following cases.
When you enter Modeling mode
• The [MODELING] key will light.
• All current assignments in the [INPUT/OUTPUT/
SOLO] “Ch1–6” and “Ch7–12” tab pages will be
memorized, the “DigiIn” button will be turned off,
and all input channel settings will be set to “1.”
“SubIn” will be muted.
• The [BOUNCE] “RecMode” tab page “RecMode”
will be set to “Input.”
• [TRACK STATUS] for track 1 and track 2 will be set
to REC, and the remaining tracks will be set to PLAY.
• In the [INSERT EFFECT] “InsAss” tab page, the
insert effect assignment will be set to “Input(In),”
and the effect type will be set to “1in2outx2.”
“InsertTo” will be set to In1→1→upper line (1) lower
line (2).
• The insert effect 1 program will be changed.
• The last-used modeling effect settings will be
restored.
When you exit Modeling mode
• The [MODELING] key will go dark.
•With the exception of tracks whose [TRACK STA-
TUS] is set to REC, the audio input settings to the
mixer will return to the state prior to when you
entered Modeling mode.
When you change the track status
If you change the [TRACK STATUS] while in Modeling
mode, the “InsertTo” setting of the insert effect will
change as follows.
• If you make settings for monaural recording by set-
ting only one [TRACK STATUS] to REC, the
“InsertTo” setting will change to “In1→1→upper line
(the track set to [REC]) lower (off)”.
• If you make settings for stereo recording by setting
two [TRACK STATUS] key to REC, the “InsertTo”
setting will change to “In1→1→upper line (the track
set to [REC]) lower line (the track set to REC +1)”.
• If you have not set [TRACK STATUS] to REC, the
“InsertTo” setting will not change.
Modeling mode