Filter
Top Products
70
Select the song, and press the [YES/OK] key.
When restoring from the USB drive
Select the song to be restored from the file list.
It is not possible to restore all songs at once.
Select the song, and press the [YES/OK] key.
5 If you are restoring a single song, select the restore-des-
tination song.
Move the cursor to “Destination,” and use the [VALUE]
dial to select the restore-destination song number.
6 Restore the data.
Select the “Exec.” button and press the [ENTER] key.
The display will ask “AreYouSure?.” Select the “Yes”
button and press the [ENTER] key to execute the opera-
tion.
If you are restoring a backup that extended across more
than one disc, you will be asked to insert the next disc
when one disc has been read. Insert the next disc, and
press the [YES/OK] key. Insert the discs in the order in
which they were backed up.
At the end of the process, you can select whether to
restore effect user data. If you do so, the effect user data
currently on the hard disk will be overwritten.
Press the [YES/OK] key.
The effect user data will be restored, overwriting the
effect user data that is on the hard disk.
If you press the [NO/CANCEL] key, the effect user data
will not be restored.
If you are restoring from a USB drive, the effect user
data will not be restored if there is no effect user data file
of the same name as the song being restored.
7 When the restore operation has been completed, the dis-
play will indicate “Completed.” Press the [YES/OK]
key.
2. Backing up and restoring effect
user data
2-1. Backing up user effect data
You can backup effect user data in the following ways.
• Backup all effect user data.
• Backup effect user data individually (only to the USB
drive)
You can also save all effect user data when you back up
song data.
When you restore this data, the effect user data current-
ly on the hard disk will be overwritten.
Backing up to CD-R/RW
Here’s how to back up all effect user data to a CD-R/
RW disc.
1 Insert a CD-R/RW disc into the CD-R/RW drive.
2 Select “BackupUserData.”
In the [SYSTEM/USB] “B-U/Rst” tab page, select “B-U/
RstType” and turn the [VALUE] dial to select “Backu-
pUser Data.” You can also select the “ ” button and
press the [ENTER] key to display “Select Backup/
Restore Type” and make your selection.
3 Select “C:CD” as the backup-destination drive.
Select the “Drive” button, and press the [ENTER] key to
open the dialog box.
Select “C:CD” and press the [YES/OK] key.
4 Make sure that “Source” is set to “EffAll.”
5 Make sure that “Destination” is set to “C:CD.”
6 Back up the data.
Select the “Exec.” button and press the [ENTER] key. A
screen will ask you for confirmation. Here you can spec-
ify the writing speed.
•Press the [YES/OK] key to begin the backup.
• When the backup has been completed, the display
will indicate “Completed.” Press the [YES/OK] key.
After data is backed up to CD-R/RW, the automatic
compare function will compare the disc to ensure that a
faulty backup CD is not created.
If you press the “Cancel” button while data is being
written to CD-R, writing will be aborted and the disc
will be incomplete. In the case of a CD-RW, the data that
had been written up to that point will be erased.
4 5
23
6