Filter
Top Products
Appendix
149
TroubleshootingMessagesAbout the CDRW-1D1200 specificationsEffect Program ListRhythm Pattern ListIndexBlock diagramMIDI implementation
chart
You can use the CDRW-1 CD-R/RW drive option to do the
following things.
• Use the CDRW-1 to backup and restore.
• Use the CDRW-1 to create audio CDs.
• Insert an audio CD into the CDRW-1, assign its output
to a mixer channel, and record or play the sound of the
audio CD.
• Export WAV files to a CD-R/RW.
• Update the system from a CD-ROM/R/RW.
Never use any internal CD-R/RW drive other than the
CDRW-1.
1. Cautions for handling
• During operation, use the unit in a horizontal position.
• Do not use the unit in extremely cold or hot locations.
• Do not use the unit in extremely humid locations.
• Do not use the unit in dusty or smoky locations.
• Do not subject the unit to vibration or strong physical
shock. In particular, this unit is vulnerable to shock dur-
ing operation (both during reading and writing).
• Normally, the drive uses software ejection, so you will
be able to open the CD tray by pressing the eject button.
However if this fails, you can forcibly eject the tray by
inserting a thin object (such as a straightened paper clip)
into the emergency eject hole.
• Do not store the unit in hot or humid locations.
• Never touch the focusing lens.
• Do not use commercially available lens cleaners.
• Do not transport the unit with a disc left in the tray.
• Do not leave the unit with the disc tray open.
CD-R/RW handling
Please observe the following points when handling
discs. Failure to observe these points may cause prob-
lems such as data not being written correctly, loss of
recorded data, or drive malfunction.
• Do not leave discs in direct sunlight, or in locations of
high temperature or high humidity.
• Do not touch the surface of a disc. Hold a disc by its
edges.
• Remove dust or dirt from the surface of a disc. To
remove dust, use an air duster or cleaner.
• Do not affix labels to a disc, or write on a disc in loca-
tions other than specified.
• Do not use chemicals or detergent to wipe a disc.
• Do not bend or drop a disc.
Responsibility for loss of data
Korg Corporation will accept no responsibility for any
damages (direct or indirect, whether sustained by the
customer or by a third party) resulting from loss of or
damage to data written on a CD-R or CD-RW disc using
the CDRW-1.
2. Installing the CDRW-1
Before installing the CDRW-1, you must turn off the
power of the D1200 and unplug the AC/DC power sup-
ply.
1 Remove the cover.
Slide the [EJECT] switch (located on the bottom of the
D1200) in the direction of the arrow, and the drive bay
cover of the D1200 will be pushed out.
2 Remove the cover.
Catch the edge of the cover that was pushed out, and
remove it in the direction shown by the arrow in the dia-
gram.
The cover may be damaged if you forcibly pull it to-
ward yourself.
Keep the cover you removed in a safe place, since you
will need it if you remove the CDRW-1.
3 Insert the CDRW-1.
Push the CDRW-1 into the D1200’s drive bay until the
front panel of the CDRW-1 is aligned with the side panel
of the D1200. Make sure that the drive is oriented in the
correct direction when you insert it into the D1200.
Press in the direction indicated by the arrow until you
hear the internal connector click into place.
About the CDRW-1
About the CDRW-1