Filter
Top Products
VA-76 Owner’s Manual—M-FX Types & controllable parameters
220
CHORUS EFFECTS
“D” means dry (no effect), while “E” means effect (no unprocessed
signal); “0” refers to the level.
28 Hexa Cho
M-Val 1 Rate 0.05~10.0 Hz
M-Val 2° Balance D>0E~D0<E
Hexa Chorus uses a six-phase chorus (six layers of chorused sound) to
give richness and spatial spread to the sound.
29 Trem Cho
M-Val 1° Trem. Rate 0.05~10.0 Hz
M-Val 2 Balance D>0E~D0<E
Tremolo Chorus is a chorus effect with added Tremolo (cyclic modula-
tion of the volume).
30 StChorus
M-Val 1° Rate 0.05~10.0 Hz
M-Val 2 Balance D>0E~D0<E
This is a stereo chorus.
31 Space D
M-Val 1 Rate 0.05~10.0 Hz
M-Val 2° Balance D>0E~D0<E
Space-D is a multiple chorus that applies two-phase modulation in
stereo. It gives no impression of modulation, but produces a trans-
parent chorus effect (the perfect “stereo maker”).
32 3DChorus
M-Val 1 Cho. Rate 0.05~10.0 Hz
M-Val 2° Balance D>0E~D0<E
This applies a 3D effect to the chorus sound. The chorus sound will be
positioned 90 degrees left and 90 degrees right.
DELAY & REVERB EFFECTS
“D” means dry (no effect), while “E” means only effect (no unproc-
essed signal).
33 St Delay
M-Val 1 Feedback -98% ~+98%
M-Val 2° Balance D>0E~D0<E
Delay is an effect that allows you repeat the input signal. By increas-
ing the Feedback value (M-Val 1), you can control the number of rep-
etitions. Negative values (–) invert the phase of the repeated signals.
34 Mod Dly
M-Val 1 Mod Rate 0.05~10.0 Hz
M-Val 2° Balance D>0E~D0<E
This effect adds modulation to the delayed sound, producing an
effect similar to a Flanger.
35 3Tap Dly
M-Val 1 Feedback -98% ~+98%
M-Val 2° Balance D>0E~D0<E
The Triple Tap Delay produces three delay sounds; center, left and
right.
36 4Tap Dly
M-Val 1 Feedback -98% ~+98%
M-Val 2° Balance D>0E~D0<E
The Quadruple Tap Delay has four delays.
37 TmCtrDly
M-Val 1° Dly Time 200m-990m/1sec
M-Val 2 Feedback -98% ~+98%
This effect allows you to use M-Val 1 to control the delay time and
pitch in realtime. Lengthening the delay time will lower the pitch,
and shortening it will raise the pitch.
38 Reverb
M-Val 1 Time 0~127
M-Val 2° Balance D>0E~D0<E
39 GteRevNr
(Normal gated reverb)
M-Val 1° Balance D>0E~D0<E
M-Val 2 Level 0~127
Gate Reverb is a special type of reverb in which the reverberant
sound is suddenly cut off (and does not gradually decrease).
40 GteRevRv
(Reversed gated reverb)
M-Val 1° Balance D>0E~D0<E
M-Val 2 Level 0~127
41 GteRevS1
(Sweep 1)
M-Val 1° Balance D>0E~D0<E
M-Val 2 Level 0~127
The reverberant sound moves from right to left.
42 GteRevS2
(Sweep 2)
M-Val 1° Balance D>0E~D0<E
M-Val 2 Level 0~127
The reverberant sound moves from left to right.
43 3D Delay
M-Val 1 Feedback -98% ~+98%
M-Val 2° Balance D>0E~D0<E
This applies a 3D effect to the delay sound. The delay sound will be
positioned 90 degrees left and 90 degrees right.
PITCH SHIFT (TRANSPOSITION) EFFECTS
44 2PitchSh
M-Val 1 Coarse1 -24 ~0~ +12
M-Val 2° Coarse2 -24 ~0~ +12
A Pitch Shifter shifts the pitch of the original sound. This 2-voice
effect has two pitch shifters, and can add two pitch shifted sounds to
the original sound.
45 Fb P.Shf
M-Val 1° Coarse1 –24 ~0~ +12
M-Val 2 Feedback –98% ~+98%
OTHER EFFECTS
46 3D Auto
M-Val 1° Speed 0.05~10.0 Hz
M-Val 2 Turn Effect on/off
The 3D Auto effect moves the location of the sound. This effect is
derived from Roland’s 3-D Sound Space technology (RSS).
47 3DManual
M-Val 1° Azimuth 180/L168~0~R168
M-Val 2 Level 0~127
Allows you to manually move the sound in a 3-D sound space.
48 Lo-Fi 1
M-Val 1° Balance D>0E~D0<E
M-Val 2 Pan L63 ~0~ R63
Lo-Fi 1 is an effect that intentionally degrades the sound quality.
49 Lo-Fi 2
M-Val 1° R.Detune 0~127
M-Val 2 Balance D>0E~D0<E
Lo-Fi 2 also degrades the sound quality and adds some noise to fur-
ther “worsen” the quality.
50 OD
→
Chors
M-Val 1 OD Pan L63 ~0~ R63
M-Val 2° ChoBalance D>0E~D0<E
This effect connects an Overdrive and a Chorus in series.
51 OD
→
Flger
M-Val 1 OD Pan L63 ~0~ R63
M-Val 2° FLBalance D>0E~D0<E
This effect connects an Overdrive and a Flanger in series.
52 OD
→
Delay
M-Val 1 OD Pan L63 ~0~ R63
M-Val 2° DlyBalance D>0E~D0<E
This effect connects an Overdrive and a Delay in series.
53 DS
→
Chors
M-Val 1 DS Pan L63 ~0~ R63
M-Val 2° ChoBalance D>0E~D0<E
This effect connects a Distortion effect and a Chorus in series.
54 DS
→
Flger
M-Val 1 DS Pan L63 ~0~ R63
M-Val 2° FLBalance D>0E~D0<E
This effect connects a Distortion effect and a Flanger in series.
VA-76.book Page 220 Friday, January 12, 2001 12:35 PM