Filter
Top Products
Insert Patching 117
DM1000 Version 2—Owner’s Manual
9
Input & Output Patching
B INSERT section
• ON/OFF.........................This button turns Insert on or off.
• OUT ...............................This parameter enables you to select outputs, slot channels, or
internal effects inputs as the Insert Out destination.
• IN....................................This parameter enables you to select inputs, slot channels, or
internal effects outputs as the Insert In source.
C COMP section
• ON/OFF.........................This button turns the compressor on or off.
• ORDER..........................This parameter determines the order of Insert patch and com-
pressor when they are inserted at the same signal path point.
With the “COMP → INS” setting, signals pass through the
compressor first, then the Insert. With the “INS → COMP” set-
ting, signals pass through the Insert first, then the compressor.
3 Move the cursor to the OUT parameter box, and rotate the Parameter wheel
or press the [INC]/[DEC] buttons to select the desired outputs, slot channels,
or internal effects inputs to be patched to Insert Out. The parameter indi-
cators are explained below:
4 Press [ENTER] to confirm the change.
If you move the cursor to another parameter box or display another page before you press
the [ENTER] button, all settings on this page will be cancelled.
5 Move the cursor to the desired IN parameter box, and rotate the Parameter
wheel or press the [INC]/[DEC] buttons to select the inputs or slot channels
to be patched to the Insert In.
Refer to the explanation regarding the Input Patch for more information on the parameter
values (see page 110).
6 Press [ENTER] to confirm the change.
7To enable the specified Insert patch, move the cursor to the ON/OFF button
in the INSERT section, and press [ENTER] to turn it on or off.
Parameter values Description
–
No assignment
S1-1–S116
Channels 1–16 of Slot 1
S2-1–S216
Channels 1–16 of Slot 2
OMN1–OM12
OMNI OUT connectors 1–12
2D1L & 2D1R
2TR OUT DIGITAL1 (L/R)
2D2L & 2D2R
2TR OUT DIGITAL2 (L/R)
FX1-1–FX1-8
Inputs 1–8 of Internal Effects Processor 1
FX2-1 & FX2-2
Inputs 1 & 2 of Internal Effects Processor 2
FX3-1 & FX3-2
Inputs 1 & 2 of Internal Effects Processor 3
FX4-1 & FX4-2
Inputs 1 & 2 of Internal Effects Processor 4
Tip: Move the cursor to an empty OUT or IN parameter box and press the [ENTER] button.
The Patch Select window appears. Rotate the Parameter wheel or press the cursor buttons to
select an item to be patched and press [ENTER]. Then, move the cursor to the YES button and
press [ENTER]. The selected item is now patched.