Filter
Top Products
Pro Tools Remote Layer 233
DM1000 Version 2—Owner’s Manual
Remote Control
17
Automation
You can view the Pro Tools Automation mode as follows:
1 Press the [F3] or [F4] button to display the channels for remote control.
2 Press the DISPLAY ACCESS [AUTOMIX] button.
The channel’s Automation settings are displayed.
While the STEREO [AUTO] button is on, the channel [SEL] button indicators also display
the channel’s Automation mode.
Pro Tools Display [SEL] Button Indicators
Auto write
Wrt
Flashing red (Record Ready)
Red (Recording)
Auto touch
Tch
Auto latch
Ltch
Auto read
Read Green
Auto off
Off Off
Tip: If you assign the parameter that controls Automation to one of the User Defined buttons,
you can control the Automation settings by holding down the programmed User Defined but-
ton and pressing the [SEL] button of the target channel. See page 274 for more information
on assigning parameters to User Defined buttons.