Filter
Top Products
30 Chapter 3—Operating Basics
DM1000 Version 2—Owner’s Manual
F MIDI indicator
This indicator appears when the DM1000 is receiving MIDI data via the MIDI IN port,
USB port, REMOTE connector, or an installed MY8-mLAN card.
G Surround mode indicator
This indicator identifies the currently-selected Surround mode (ST=stereo, 3-1, 5.1, or
6.1) (see page 125).
H Sampling rate indicator
This indicator identifies the DM1000’s current sampling rate: 44.1 kHz (44k), 48 kHz
(48k), 88.2 kHz (88k), or 96 kHz (96k).
I Timecode counter
This counter displays the current position in the MIDI timecode being received via the
MIDI IN port, USB port, REMOTE connector, or an installed MY8-mLAN card. It
works in unison with the timecode counter on an optional MB1000 Meter Bridge.
If MIDI clock is selected as the timecode source on the Setup | Time Ref page, this
counter indicates the current MIDI clock position in bars:beats:clocks.
J Page title
This section indicates the title of the current page.
K Channel name
Depending on which page is currently selected, the channel name is the Long name of
the channel currently selected by its corresponding [SEL] button or the cursor buttons.
L Page area
This page area displays various page contents.
M Page tabs
These tabs enable you to select a display page.
N Tab Scroll arrows
These arrows indicate that more pages are available.
Selecting Display Pages
To select a display page:
1 Press the corresponding button on the top panel to select the desired page
group.
Display pages are grouped by function. To select a page group, press the [DISPLAY] button
in the following sections: AUX SELECT, ENCODER MODE, ROUTING, EQUALIZER,
MONITOR, USER DEFINED KEY. You can select additional page groups by pressing the
desired button in the DISPLAY ACCESS section.
2You can select pages that have currently-displayed tabs by pressing the
[F1]–[F4] buttons.
If the selected display page group contains multiple pages, press the [F1]–[F4] buttons
below the corresponding tab to select a specific page.
3To select a page for which a tab is not currently displayed, press either the
Left or Right [ ]/[ ] Tab Scroll button (depending on where the page is
located) to display the page tab, then press the corresponding [F1]–[F4] but-
ton.
If display page groups contain more than four pages, either the left or right arrow appears.
To display the currently-hidden tabs, press the Right or Left [ ]/[ ] Tab Scroll button.
You can also select a page from a page group as follows: