Filter
Top Products
26 Chapter 2—Control Surface & Rear Panel
DM1000 Version 2—Owner’s Manual
SLOT Section
A SLOT 1 & 2
You can insert optional mini-YGDAI cards into these slots. (See page 28 for more informa-
tion on installing these cards.)
Digital I/O & Control Section
A METER connector
This connector enables you to connect an optional MB1000 Meter Bridge.
B CONTROL connector
This 25-pin D-sub connector provides access to the GPI (General Purpose Interface).
Through this connector, the Talkback function can be turned on and off from external
equipment, or external equipment can be started or stopped from the DM1000 (see
page 276).
C SMPTE TIME CODE INPUT connector
This balanced XLR-3-31-type connector is used to input SMPTE timecode to synchronize
the Automix function.
D REMOTE connector
This 9-pin D-Sub connector is used to remotely control external equipment that supports
the Yamaha AD8HR, AD824 and Sony P2 Protocol (remote control commands that are
used on TASCAM DA-98HR and other professional video recorders). Use a reverse cable to
connect an AD8HR/AD824, and use a straight cable to connect a P2 Protocol device. Use a
reverse cable to connect two DM1000s to each other. Connecting two DM1000s to each
other enables communication via MIDI Protocol and SOLO Logic synchronization.
This connector can also be used to control the DM1000 from a video editor that supports
the ESAM II protocol. In this case, use the dedicated cable to make the connection (see
page 264).
E MIDI IN & OUT ports
These standard MIDI IN and OUT ports enable you to connect the DM1000 to other MIDI
equipment.
F TO HOST USB port
This USB port enables you to connect a computer equipped with a USB port.
SLOT
SLOT
1
WORD CLOCK
INOUT
CONTROL
INOUT
TO HOST
USB
REMOTE MIDI
SMPTE IN
COAXIAL AES/EBUCOAXIALAES/EBU
2
2
1
2TR IN
DIGITAL
METER
1
432
1
6 7 8 9 J L K5