Filter
Top Products
208 Chapter 16—Automix
DM1000 Version 2—Owner’s Manual
4 Move the cursor to the desired Job button in the Job Type section, then press
[ENTER].
The following Jobs are available. Certain Jobs feature an extra parameter below the TIME
SETTING section.
■ ERASE
This button erases the specified range of Automix data.
■ COPY
This button copies the specified range of Automix data to another position. When you select
this button, the SOURCE and COPY TO sections appear below the TIME SETTING sec-
tion.
• SOURCE section
This section enables you to select the copy source Automix.
• COPY TO section
- TIME
This parameter specifies the start point to which the specified data is to be copied. (The
number in parentheses on the right indicates the end point of the destination.) You can
also capture the start point on-the-fly by moving the cursor to the TO button and press-
ing the [ENTER] button to capture the current position. To modify the captured posi-
tions, move the cursor to the value you wish to change, then rotate the Parameter wheel
or press the [INC]/[DEC] buttons. Press the [ENTER] button to reset the cur-
rently-selected digit to “00.”
-CH
This parameter specifies the channel to which you want to copy the specified data. If
multiple channels are selected as the copy source, use the CH parameter box to specify
the number of the top channel in the destination. (The number in parentheses on the
right indicates the number of the last channel in the destination.)
For example, if eight channels are selected as the copy source and you specify “17” in the
CH parameter box, the copy destination will be Channels 17 through 24.