Filter
Top Products
Using Effects Processors via Aux Sends 157
DM1000 Version 2—Owner’s Manual
Internal Effects
13
• FX1-1–FX4-2 ................Other effects processor outputs
You cannot select outputs FX1–3 to FX1–8. In addition, you
cannot select the output of the effects processor you are cur-
rently using.
To use the internal effects processors via Aux Sends, select Aux 1–8 (in most cases).
You can patch a different signal to the other input of 2-in/2-out effect programs.
4To patch a signal output from the effects processor, move the cursor to the
desired OUT parameter box, rotate the Parameter wheel to select the signal
destination from the following options, then press [ENTER].
• – .....................................No assignment
• CH1–48 .........................Input Channels 1–48
• INS CH1–48..................Input Channel Insert In
• INS BUS1–8 ..................Bus Out 1–8 Insert In
• INS AUX1–8..................Aux Out 1–8 Insert In
• INS ST-L & INS ST-R...Stereo Out Insert In
• FX1-1–FX4-2 ................Other effects processor inputs
You cannot select the input of the effects processor you are cur-
rently using.
To use the internal effects processors via Aux Sends, select CH 1–48 (in most cases). The
channels you assign here will become the effects return channels.
You can patch a different channel to the other output of a 1-in/2-out or 2-in/2-out effect
program to create stereo effects.
5 Adjust the level of Aux Sends patched to the effects processor.
Refer to chapter 8 “Aux Sends” on page 93 for information on setting the Aux Sends.
6 Adjust the level, pan, and EQ of the Input Channels patched to the effect
outputs.
Tip:
•You can patch a signal to multiple effect inputs.
•Move the cursor to an IN parameter box and press the [ENTER] button. The Patch Select
window appears. This window enables you to select the input source quickly.
Tip:
•You can also use the Patch Select window to set the OUT parameter boxes, as explained in
Step 3.
• The number of inputs and outputs available for each effect varies depending on the type of
effect programs initially recalled.
Note: Yo u cannot select a channel as the destination of multiple effect signals. If you select a
channel that is already selected in another OUT parameter box, that OUT parameter box
switches its indicator to “–” (not assigned).
Note: Do not raise the level of the Aux Sends (patched to the effects processor) on the effects
return channels. Otherwise, the signal will return to the same channel, causing a signal loop
and possibly damaging your speakers.
Tip: Use the Master layer fader to adjust the final Aux Send output level. At this time, you
can view the level on the Meter | Master page (see page 39).
Tip: To mix the effects sound returned via the Aux Sends with the original dry sound, set the
effect’s MIX BALANCE parameter to 100% (only the effects sound will be output).