Filter
Top Products
212 Chapter 16—Automix
DM1000 Version 2—Owner’s Manual
E SELECTED CH
When this option is on, only events of the channels currently selected by the channel
[SEL] buttons are displayed in the list.
F Event select buttons
These buttons select the type of events to be displayed in the event list.
G INSERT
This button inserts a new event in the position selected in the event list.
H LOCATE
This button locates events at (or closest to) the timecode position indicated on the Cap-
ture memory display.
I Capture memory display
This display counter indicates the captured timecode position.
J CAPTURE
This button captures the current timecode position. Up to eight timecode values can be
captured and stored in the eight Capture memories.
K Capture memory
This box indicates the number of the currently-selected Capture memory (1–8).
2 Use the Event select buttons to select the type of events to be displayed in
the event list.
The format of the list varies depending on the selected event. The following table shows the
events that correspond to the Event select buttons, and the list format:
Button Events Listed List Format
SCENE/LIB
Library and Scene recall events TIME CODE, CH, SCENE/LIB
FADER
Channel Fader events (Inputs Channels, Bus
Out masters, Aux Out masters, Group Master
Levels, and the Stereo Out)
TIME CODE, CH, dB, SEC
ON
Channel Mutes (ON/OFF), and Group Master
On
TIME CODE, CH, ON/OFF
PAN
Pan TIME CODE, CH, L-C-R
SURR-PAN
Surround Pan TIME CODE, CH, SURR
SURR-LFE
Surround LFE TIME CODE, CH, dB
SURR-DIV
Surround DIV TIME CODE, CH, DIV
SURR-RDIV
Surround RDIV TIME CODE, CH, RDIV
EQ-ON
EQ On/Off TIME CODE, CH, ON/OFF
EQ-FREQ
EQ Frequency TIME CODE, CH, BAND/Hz
EQ-Q
EQ Q TIME CODE, CH, BAND/Q
EQ-GAIN
EQ Gain TIME CODE, CH, BAND/dB
AUX
Aux Send 1–8 levels TIME CODE, CH, AUX, dB
AUX ON
Aux Send 1–8 mutes TIME CODE, CH, AUX, ON/OFF
Tip: When the SELECTED CH check box is on, only events of the currently-selected channel
are displayed.
Note: If the data size of the selected event exceeds 1.75 MB, the message “Automix Work Mem-
ory Full!” appears, and not all events may be displayed. In this case, check the SELECTED
CH check box to display only events of the selected channel.