Filter
Top Products
Using Fader Group Master 151
DM1000 Version 2—Owner’s Manual
Grouping Channels & Linking Parameters
12
4 Use the cursor buttons to select parameters, then use the Parameter wheel,
INC/DEC buttons, or [ENTER] button to set the parameters.
• INPUT/OUTPUT FADER MASTER....When this check box is checked, you can set the
master levels for the Fader groups. The result-
ant Channel level equals the corresponding
Channel fader level plus the Group Master
level.
• ALL NOMINAL............This button resets the master levels for all Fader groups to nom-
inal.
• ON/OFF.........................This turns each Input Fader group on or off. This function
works like a VCA mute on an analog mixing console.
• Faders ............................These faders adjust the master levels of the Fader groups. Fader
knobs are highlighted when faders are set to 0.0 dB. Press the
[ENTER] button to set the currently-selected fader to 0.0 dB.
You can also control the parameters from the channel strips on the control surface as
described below by using the User Assignable Layer of the Remote Layers. See page 272 for
information on the User Assignable Layer.
• Encoders........................The Encoders are not available.
• [AUTO] buttons...........These buttons are used to control the Fader Group Master
On/Off and the master level during Automix.
• [SEL] buttons ...............These buttons move the cursor on the In Master page or Out
Master page.
• [SOLO] buttons ...........These buttons turn the Solo function of each Fader group on
and off. You can monitor all the channels in each Fader group.
• Channel Faders ............The channel faders enable you to set the master level for each
Fader group.