Filter
Top Products
Selecting Fader Modes 35
DM1000 Version 2—Owner’s Manual
3
Operating Basics
Selecting Fader Modes
The function of channel faders (1–16) depends on the selected Layer and Fader mode.
1 Select a layer that includes the desired channel (see page 33).
2 Press the FADER MODE [FADER/AUX] button to select a Fader
mode.
•When the [FADER]indicator
lights up: .............................................. You can use channel faders to
control Input Channel levels or
Output Channel (Aux Out 1–8,
Bus Out 1–8) master levels.
•When the [AUX] indicator
lights up: .............................................. You can use channel faders to control Input
Channel Aux Send levels.
The following table shows the channel fader functions for each Layer and Fader mode.
LAYER buttons Fader Mode
Channel Strip Fader
1–8 9–16
[1-16] button
Fader Input Channels 1–16 level
Aux Input Channels 1–16 Aux Send level
[17-32] button
Fader Input Channels 17–32 level
Aux Input Channels 17–32 Aux Send level
[33-48] button
Fader Input Channels 33–48 level
Aux Input Channels 33–48 Aux Send level
[REMOTE 1] button
Fader
Operation depends on the selected target (see
page 215).
Aux No operation No operation
[REMOTE 2] button
Fader
Operation depends on the selected target (see
page 215).
Aux No operation No operation
[MASTER] button
Fader
Aux Send master 1–8
output level
Bus Out master1–8 out-
put level
Aux No operation No operation
Note: Yo u cannot select Aux mode while the Master layer is selected. If you switch to the Master
layer while the FADER MODE [AUX] indicator is lit, the indicator automatically turns off
and the [FADER] indicator lights up.
FADER MODE
FADER
AUX