Filter
Top Products
120 Chapter 10—Control Room Monitoring
DM1000 Version 2—Owner’s Manual
Solo Setup
For solo setup, press the MONITOR [DISPLAY] button repeatedly until the Monitor | Solo
page appears.
This page contains the following parameters:
A SOLO
This parameter turns the Solo function on or off. By default, it is set to Enabled.
B MODE
This parameter determines how the Solo function works. There are two options. The
setting affects only Input Channels.
• RECORDING............... In Recording Solo mode, soloed Input Channel signals are fed
to the Solo bus and output via the Control Room Outputs.
Other buses (Stereo bus and Bus 1–8) are unaffected by this
mode.
• MIXDOWN..................In Mixdown Solo mode, soloed Input Channel signals are fed
to the Stereo bus and output via the Control Room Outputs.
Unsoloed Input Channels are not fed to the Stereo bus while
the Solo function is enabled.
C SEL MODE
This parameter determines how the Input Channels will be soloed when you press the
[SOLO] button of each Channel. There are two options.
• MIX SOLO.................... In Mix Solo mode, any number of channels can be soloed
simultaneously.
• LAST SOLO .................. In Last Solo mode, only one channel can be soloed at a time by
pressing the [SOLO] button. The Solo function that was previ-
ously enabled for channels is automatically cancelled.
Tip:
•Recording Solo mode is convenient when you wish to monitor certain Input Channels
while recording, since the Stereo bus and Bus 1–8 signals are unaffected
•Mixdown Solo mode is useful when you wish to mute unsoloed Input Channels and feed
soloed Input Channel signals to the Stereo bus during mixdown.
4
7
1
5
8
9
6
32