Filter
Top Products
Pro Tools Remote Layer 225
DM1000 Version 2—Owner’s Manual
Remote Control
17
■ USER DEFINED KEYS section
• [1]–[12] buttons
You can assign one of 164 parameters to each of these buttons. In particular, if you assign
any of 53 Remote Control parameters to these buttons, you can operate the transport sec-
tion and select various Pro Tools modes from the DM1000 top panel. See page 274 for more
information on assigning the parameters to the buttons.
Parameter Function
DAW REC
Places Pro Tools in Record Enabled mode. The button indicator flashes while
the transport section is stopped. The indicator lights up when recording starts.
DAW PLAY
Starts playback from the current cursor position.
DAW STOP
Stops playback and recording.
DAW FF
Fast forwards the cursor position.
DAW REW
Fast rewinds the cursor position.
DAW SHUTTLE
Switches Wheel mode to Shuttle.
DAW SCRUB
Switches Wheel mode to Scrub (Jog).
DAW AUDITION
You can audition the pre-roll, post-roll, in-point area, or out-point area by
holding down the button to which this function is assigned and pressing a
button to which DAW PRE, DAW POST, DAW IN, or DAW OUT is assigned.
DAW PRE
Plays back from the pre-roll point up to the beginning of the selected area.
DAW IN
Plays back from the beginning of the selected area for a duration specified as
the pre-roll.
DAW OUT
Plays back to the end of the selected area for a duration specified as the
post-roll.
DAW POST
Plays back from the end of the selected area for a duration specified as the
post-roll.
DAW RTZ
Moves the playback cursor to the beginning of the session.
DAW END
Moves the playback cursor to the end of the session.
DAW ONLINE
Toggles between on-line and off-line.
DAW LOOP
Toggles between Loop Playback on and off.
DAW QUICKPUNCH
Toggles between QuickPunch on and off.
DAW AUTO FADER
Correspond to the Automation Overwrite (Auto Enable) functions.
DAW AUTO MUTE
DAW AUTO PAN
DAW AUTO SEND
DAW AUTO PLUGIN
DAW AUTO SENDMUTE
DAW AUTO READ
Select Automation modes.
DAW AUTO TOUCH
DAW AUTO LATCH
DAW AUTO WRITE
DAW AUTO TRIM
DAW AUTO OFF
DAW AUTO SUSPEND
Cancels Automation recording and playback for all channels. When Automa-
tion is interrupted, the LED flashes, and channel strip controls maintain the
current settings.
DAW AUTO STATUS
Displays the channel Automation mode (Read, Tch, Ltch, Wrt, or Off). The
mode setting appears at the bottom of each channel on a Channel or Meter
Display page when you press and hold the button to which this function is
assigned.
DAW GROUP STATUS
Displays a Group ID (to which each channel belongs) below each channel
number on a Channel or Meter Display page (in all caps for a main group and
in lowercase letters for a sub-group).