Filter
Top Products
Metering 41
DM1000 Version 2—Owner’s Manual
3
Operating Basics
5 If you selected the Stereo page, use the METER MODE parameter to select
one of the following two metering signal types:
• C-R .................................Control Room Monitor output signal
• STEREO.........................Stereo Out signal
This parameter setting affects the meters on the Meter | Master page, the ST meter on the
Stereo page, and the stereo meter on the right side of the display.
6To activate the Peak Hold function, move the cursor to the PEAK HOLD but-
ton, then press [ENTER].
The PEAK HOLD button turns on, and the peak level is held on the meters on the page and
on the Peak Meter Bridge. To cancel the Peak Hold function, turn the PEAK HOLD button
off. If an optional MB1000 Peak Meter Bridge is installed, its Peak Hold function switches
in unison with the DM1000 meters.