Filter
Top Products
288 Chapter 20—Other Functions
DM1000 Version 2—Owner’s Manual
3 Press the DISPLAY ACCESS [SETUP] button repeatedly until the Setup |
Remote page appears.
This page contains the following parameters:
A REMOTE FUNCTION
This parameter selects a device to be connected to the DM1000 REMOTE connector.
B HA section
This section enables you to specify the slot channels that will receive eight channel sig-
nals from AD8HR/AD824s that have their ID numbers set to 1 through 4.
C HA CONTROL section
This section enables you to set the AD8HR/AD824 channel 1–8 gain and the Phantom
power on or off.
• ID #1–#4........................ These buttons select the AD8HR/AD824s you want to control.
• 1–8 (1st row)................. These parameter controls adjust the gain for AD8HR/AD824
channels 1–8.
• +48V ..............................When you turn on these buttons, the phantom power on the
corresponding channels will be turned on.
• 1–8 (2nd row)............... These parameter controls adjust the cut-off frequency of the
high-pass filter for the corresponding channels. They are
grayed out and cannot be set for the AD824.
• HPF................................ When you turn on these buttons, the high-pass filter on the
corresponding channels will be turned on. They are grayed out
and cannot be set for the AD824.
4 Make sure that the REMOTE FUNCTION parameter is set to “HA,” and in the
HA section select the slot channels that receive signals from the
AD8HR/AD824s.
5 Use the parameter controls and buttons in the HA CONTROL section to set
the channel gain, turn on/off the phantom power, and adjust the high-pass
filter.
2
1
3