Filter
Top Products
134 Chapter 11—Surround Functions
DM1000 Version 2—Owner’s Manual
• ...................... The sound image moves between front and rear while tracing an arc.
With this pattern, you can also fine-tune the radius and shape of the
arc using the WIDTH, DEPTH, OFFSET ( ), and OFFSET ( )
parameters.
• ...................... The sound image moves while tracing a circle or oval. With this pat-
tern, you can also fine-tune the radius and shape of the circle or oval
using the WIDTH, DEPTH, OFFSET ( ), and OFFSET ( ) param-
eters.
4 If necessary, fine-tune the trajectory by editing the WIDTH, DEPTH, OFFSET
( ), and OFFSET ( ) parameter values.
5To set the surround pan position, move the cursor to anywhere outside the
parameter boxes, then rotate the Parameter wheel.
6To adjust the surround pan using the Joystick, press the SELECTED CHANNEL
[GRAB] button (the button indicator lights up), then operate the Joystick.
In this way, you can move the current pan position icons ( ) directly and quickly. Even if
the [GRAB] button is turned off, placing the small square ( ) over the small diamond ( )
will automatically turn on the [GRAB] button.
This Joystick function can be disabled by the Joystick Auto Grab preference (see page 268)
on the Setup | Prefer1 page.
7To link the surround pan settings of two channels displayed on the page,
turn on the ST LINK button.
Use the PATTERN parameter box below the ST LINK button to specify how you want the
linked surround pan to move.
Tip: You can also adjust the pan position using the Encoders if you assign the surround pan
parameters to the Encoders.
40 48 44 44 20 32 28 56 32 24
44 48 32 24 24 24 60 40 52 40