Filter
Top Products
Surround Monitoring 143
DM1000 Version 2—Owner’s Manual
Surround Functions
11
A MUTE/SOLO section
This section enables you to mute or solo Surround Monitor Channels for each Bus.
• SOLO .............................This button turns the Surround Monitor Solo function on or
off. When this button is turned on, you can select speaker icons
() to solo certain Buses.
• buttons.................These buttons mute or unmute the speakers. The meters con-
nected to the speaker icons indicate the signal level of the cor-
responding Buses.
B SETTING section
• MIX MONITOR SOURCES .............. When this check box is checked, you can select
the [BUS] button and [SLOT] button simulta-
neously as the monitoring source.
• SLOT 1 & 2 ........................................... These buttons determine which Slot Inputs are
monitored through the Surround Monitor when
you press the [SLOT] button. Turning on both
buttons 1 and 2 mixes the two slot signals.
• C-R TO MONITOR L/R..................... When this button is turned on, the Left and Right
Surround Monitor Channels are fed to the Con-
trol Room Monitors.
C STATUS section
This section enables you to set the output levels of the currently-selected Surround
Monitors.
• SURROUND MODE ...This parameter displays the current Surround mode.
• MONITOR LEVEL.......This parameter indicates the current Surround Monitor level.
• SET SPL85.....................This button enables you to calibrate the volume setting of the
[MONITOR LEVEL] control to 85 dB SPL, the cinema stan-
dard for setting up Surround Channel Monitor speakers, and
then store the value.
• SNAP TO SPL85...........Turning on this button resets the [MONITOR LEVEL] control
setting to the value stored by the SET SPL85 button.
3 Move the cursor to the SET SPL button, then press [ENTER] to turn on the
button.
The volume setting of the [MONITOR LEVEL] control is calibrated to 85 dB SPL and
stored.
If you store the cinema standard level in this way, moving the cursor to the SNAP TO SPL85
button and pressing [ENTER] always restores the stored value, even after you adjust the
[MONITOR LEVEL] control.
Note: The Surround Monitor Mute and Solo functions are reset to the default condition when
you change the Surround mode.
Tip: When the SET SPL button is turned on, the standard value (85.0 dB ) indicated in the
MONITOR LEVEL box is applied to the stored [MONITOR LEVEL] control setting.