Filter
Top Products
228 Chapter 17—Remote Control
DM1000 Version 2—Owner’s Manual
Configuring Sends A–E as Pre or Post
You can set Pro Tools channels for the selected Sends (A–E) to pre or post.
1 Press the AUX SELECT [AUX 1]–[AUX 5] buttons to select the desired Sends
(A–E).
The selected button indicators light up. Send pre/post status can be viewed in Channel Dis-
play or Meter Display mode by pressing and holding down the [AUX1]–[AUX5] buttons.
2 Press the Encoder push-switches for the desired channels.
Pressing the Encoder push-switches repeatedly toggles between pre and post.
You can set Sends as pre or post by pressing the Encoder push-switches if faders, Encoders,
and [ON] buttons are in Flip mode. See page 228 for more information.
Setting Send Levels
You can adjust Pro Tools Send (A–E) send levels as follows.
1 Press the AUX SELECT [AUX 1]–[AUX 5] buttons to select the desired Sends
(A–E).
2 Rotate the Encoders for the desired channels.
You can set Send levels by rotating the Encoders if faders, Encoders, and [ON] buttons are
in Flip mode. Refer to “Flip Mode” for more information.
Muting Sends A–E
You can mute Sends by pressing the [ON] buttons if faders, Encoders, and [ON] buttons
are in Flip mode. Refer to “Flip Mode” for more information.
Panning Sends A–E
You can pan only Sends assigned to stereo destinations by rotating the Encoders if faders,
Encoders, and [ON] buttons are in Flip mode. Refer to the next section for more informa-
tion.
Flip Mode
In Flip mode, you can use the faders, Encoders, and [ON] buttons to control send levels,
pre/post positions, and mute settings as shown in the following table.
1 Press the FADER MODE [FADER/AUX] button.
The FADER MODE [FADER] and [AUX] indicators flash alternately, and the SELECT
ASSIGN parameter on the display indicates “FLIP.”
2 Press the AUX SELECT [AUX 1]–[AUX 5] buttons to select the desired Sends
(A–E).
The button indicator of the selected send lights up.
Control Normal mode Flip Mode
Faders
Channel level Send level
Encoders
Channel pan/send level Send pan
Encoder push-switches
Encoder mode is Pan: inactive;
Encoder mode is Send level: Send pre/post
Send pre/post
[ON] buttons
Channel mute Send mute