Filter
Top Products
PARAMETER SELECT Button
Pressing the PARAMETER SELECT button changes the parameters to be
adjusted by the and knobs. Repeated pressing of this button cycles
the four choices: threshold or ratio—>attack or release—>delay or gain
_
>
threshold or release. The appropriate LED will light (orange) showing which
set of parameters are in use: THL and RATIO, ATK and RLS, DLY and GAIN.
No LED will light when the THL and the RLS are in GATE mode.
Additionally, when in GATE mode, the top knob toggles between THL
(threshold) and ATK (attack).
THL and RATIO LED
When this LED is illuminated (orange), THL (threshold) and RATIO
attributes for the COMPRESSOR can be adjusted. The knob
adjusts the threshold level, and the knob adjusts the ratio level.
These parameters can also be adjusted in the [DYNAMICS] window by
highlighting the selection soft knob, and turning the JogDial to
change the level.
ATK and RLS LED
When this LED is illuminated (orange), ATK (attack) and RLS (release)
attributes for the COMPRESSOR can be adjusted. The knob
adjusts the attack level, and the knob adjusts the release level.
These parameters can also be adjusted in the [DYNAMICS] window by
highlighting the selection soft knob, and turning the JogDial to
change the level.
DLY and GAIN LED
When this LED is illuminated (orange), DLY for the channel and GAIN
attributes for the COMPRESSOR can be adjusted. The knob
adjusts the delay time of the channel, and the knob adjusts the
gain. You can adjust the Delay in either msec or samples. Simply select
the field you wish to adjust on the [CHANNEL] window on the LCD.
These parameters can also be adjusted in the [DYNAMICS] window by
highlighting the selection soft knob, and turning the JogDial to
change the level.
Chapter 9
DA7 Users’ Guide
9
-
4
9
Dynamics/
Delay