Filter
Top Products
Chapter 11
DA7 Users’ Guide
11
-
17
11
MIDI
[TABLE SETUP] Area
Selecting a Table
After turning on the button in the [MIDI>RMT] window, cursor to a
channel. Select the [SOLO] or [ON] button, a [PAN] soft knob, or a
[FADER]. Press the ENTER button, and the pop up window [REMOTE
COMMAND EDIT] [TABLE SETUP] will appear.
With the cursor highlighting [SW1], rotating the JogDial will scroll
through the selections [SW1], [SW2], [SW3], [KNOB1], [KNOB2],
[KNOB3], [FADER1], [FADER2], and [FADER3]. The Step number of
the table, which is located in the field immediately to the right, is
displayed automatically.
Edit of Data Table
Cursor to the [EDIT] button, and press the ENTER button. The [STEP
SELECT] portion will appear.
Cursor to the step number portion, and select the number with the
JogDial. When the data table is for a Switch, the step number is fixed to
2. When the data table is Pan Knob or Fader, select a step number from
2, 32, 64, or 128. Even division is set for divided data tables. (With the
number of 2, the center position of the Pan Knob or Fader divides the
data area into two.) The initial value is 32 for the Knob and 128 for the
Fader.
Cursor to the data table portion, and select a step to be edited with the
JogDial.
Cursor to the Letter Box on the right side. Select data with the JogDial,
and press the ENTER button. Switches have two steps, On and Off, and
are indicated by 00H for On and 7FH for Off. The Pan knob has 32 steps
from 00H to 1FH, and Fader has 128 steps from 00H to 7FH.
Button
Cursor to this button, and press the ENTER button to fix data and end
the edit. The [STEP SELECT] portion will disappear.
Button
Cursor to this button, and press the ENTER button to cancel the edited
data and end the edit. The [STEP SELECT] portion will disappear.
1
2
3
4