Filter
Top Products
10-2 AUX Section Controls
The AUX section contains a LEVEL ON/OFF knob and LED buttons for
AUXs 1-6, PRE (pre-fader), and FADER CONTROL.
[LEVEL] ON/OFF Knob
To assign an aux to a selected channel, press one of the AUX 1-6
LED buttons to select it (green), and then press the LEVEL
ON/OFF knob to activate the aux assignment. or status is
shown in the [CHANNEL] window and in the respective [FADER
CONTROL>AUX] window. The AUX LED field of the respective
Channel Strip also reflects the aux assignment.
Turn the LEVEL ON/OFF knob to adjust the aux send level for
the selected channel to the specified aux. The level is expressed
in a numeric value in the associated window data field.
PRE LED Button
Press the PRE (pre-fader) LED button (red) to enable the pre-fader condition
for the selected channel. This operation uses the signal before the fader and
sends it to the selected aux output. When the PRE LED button is off, the
DA7 defaults to (post fader) condition for the selected channel and uses
the signal after the fader as the send to the selected aux output.
Chapter 10
DA7 Users’ Guide
10
-
3
10
AUX
AUX Section
Level ON/OFF knob
FADER CONTROL
ON LED button
PRE (pre-fader)
LED button
Aux assign
LED buttons