Filter
Top Products
MASTER RESET
If you’ve already pushed as many buttons as possible after powering up the
DA7 to see what it could do, or if you have accidentally changed any of the
factory presets and cannot figure out what you have done, you need to know
about the master reset command.
To reset the DA7, turn the power off, and then simultaneously press and
hold the METER and CHANNEL buttons in the MASTER DISPLAY section
of the Top Panel. While pressing these two buttons, turn the power on. Hold
the buttons down until the Channel window is displayed. Doing this will
reset the DA7 to the factory presets.
Also, there are a few windows on the LCD screen that you should acquaint
yourself with, that contain most of the information you need to know about
the current status of your mixer.
They are the [UTILITY>CONFIG], [SOLO/MON], [D-I/O>INPUT SET] and
[MIDI>BULK] windows. Pressing the relevant Top Panel buttons for these
features will display the windows in the LCD. Once you are in any window,
you will find the window group selection buttons on the bottom of the
screen. These buttons show all the windows within the window group. The
window group you are in is indicated on the top line of the [taskbar]. See
Chapter 2, page 2-20 for information on the LCD screen. Cursor to the
bottom of the current window, choose a window selection button, and press
the ENTER button to bring that window into the LCD. You can also access
the selections by pressing the Top Panel button again to toggle through the
selections.
Chapter 1
DA7 Users’ Guide
1
-
8
1
Introduction
METER
button
CHANNEL
button
MASTER DISPLAY Section