SCENE MEMORY Section
SCENE MEMORY allows you to store and recall complete mixer setups and
functions. There are fifty registers, numbered 01 through 50, available for
storage of mixer settings. Memory 00 is reserved for Automation.
Press either the WRITE LED button or the READ LED button (orange) to
select it and display the [ReaD/WriTe] window of the [SCENE MEMORY]
window group on the LCD screen of the Display Bridge.
There are two windows in the group; [RD/WT], and [XFADE]. The [RD/WT]
window is always the initial window displayed when either button is
selected. To change to the [XFADE] window, use the ARROW buttons to
navigate to the respective window selection button, and then press the
ENTER button, or press either the WRITE or READ LED buttons a second
time.
When the [RD/WT] window is displayed, the JogDial will scroll the [SCENE
MEMORY] list area of the window. This allows you to quickly access a
previously stored scene, locate an empty scene memory, or locate a scene
memory to be overwritten. By pressing the ENTER button after a scene has
been located, the mixer will immediately assume the setting for the stored
scene.
The MEMORY readout display will flash the memory number that is selected
until it is recalled. The selected memory will be displayed without flashing
once it has been recalled.
While the [RD/WT] window is displayed, pressing the ENTER button will
immediately overwrite the current scene memory with the settings that are
on the mixer at the moment the ENTER button is pressed, unless the
register is write-protected. See Chapter 15, Scene Memory for additional
information.
LIBRARY Section
Chapter 2
DA7 Users’ Guide
2
-
18
2
DA7 Tour
14
15
SCENE MEMORY Section
LIBRARY Section
WRITE LED
button
READ LED
button
STORE LED
button
RECALL LED
button