Filter
Top Products
[SOLO MONITOR] Area
There are four operational parameters for the [SOLO MONITOR]:
[POSITION] Area
SOLO can be assigned in these ways:
Button
When assigned to this button, the solo source monitoring is pre-
fader. When enabled, the button is displayed in inverse
video.
Button
When assigned to this button, the solo source monitoring is post-
fader. Pan will have no effect. Raising and lowering the fader for a
channel in the SOLO mode will change the level of the SOLO
monitoring.
Button
When assigned to this button, the solo source monitoring is post-
fader and post-pan. In this mode you will hear the signal as it
appears in stereo mode and at the level it had been before you
selected it.
[MODE] Area
Mode has two conditions that apply to SOLO monitoring:
Button
Only one source at a time can be selected for SOLO monitoring.
Button
You have the option of selecting multiple SOLO channels
simultaneously.
or Buttons Area
In the [SOLO MONITOR] area the and buttons toggle and
enable or disable SOLO for the system.
OFF
ON
ON
OFF
Chapter 16
DA7 Users’ Guide
16
-
4
16
Utility
●
●
●
●
SOLO MONITOR Area
●