Filter
Top Products
Connections
With the power to the DA7 off, insert two optional ADAT cards into SLOT 1
and SLOT 2. Carefully screw these cards into their respective slots in the
DA7 so they are properly grounded. Each ADAT machine is connected to an
option card via two optical cables, one In and one Out. The 8-track ADAT
signal in SLOT 1 is assigned to inputs 17-24, and the 8-track ADAT signal in
SLOT 2 is assigned to inputs 25-32.
The output sources into the ADAT can be selected from the [D-I/O>SLOT
OUT] window.
Refer to Chapter 12, D-I/O for additional information.
Wordclock Setup
The Word Clock master is the ADAT connected to SLOT 1, and the ID setting
must be set to zero. From the [D-I/O>INPUT SET] window scroll to SLOT 1
and select it as the Word Clock master source. This will tell the DA7 that the
device in SLOT 1 is the Word Clock master.
ADAT + BRC + DA7
This diagram shows how to connected an ADAT and a BRC Clock master to
the DA7.
To verify that the setup is properly connected, go to the [D-I/O>INPUT SET]
window. On the lower left, where SLOT 1, SLOT 2, and SLOT 3 are
indicated, the crosshatching will go away when a proper connection has
been made.
Chapter 17
DA7 Users’ Guide
17
-
3
17
Options
ADAT + BRC + DAT GRAPHIC
ADAT ID2
ADAT ID1
SYNC IN
SYNC OUT
OUT
OUT
OUT
IN
IN ININ OUT
SYNC IN
SYNC OUT
WCK master
SMPTE IN
EFX Device
DAT
S/PDIF/ I/O
AES/EBU I/O
WR-
ADAT
WR-
ADAT
DA7
TO PC
CR monitor out
PC
Power amp
SP SP
WCK OUT
WR-
SMPTE
WCK IN
BRC ID 0