Filter
Top Products
Chapter 11
DA7 Users’ Guide
11
-
13
11
MIDI
Setting of Bulk Command Reception
Switch the setting or to receive a bulk data or bulk out transmission
request from outside by pressing the ENTER button.
You can choose whether or not to ignore a request made by other devices.
Cursor to [Rx], and press the ENTER button. Each time the button is pressed,
and toggles.
Data Transmission Request and Transmission
Press the button to request transmission of selected data from
another DA7, and load the data. To cancel the operation, cursor to the
button and press the ENTER button. When the operation is completed, the
indication of "during execution" disappears and the button appears
as inverse video.
Press the button to transmit selected data to a device.
To cancel the transmission, cursor to the button and press the ENTER
button. When the transmission is completed, the indication of "during
execution" disappears and the button appears as inverse video.
Receiving/Sending Data
Display the [MIDI>BULK] window.
Press the MIDI button to display the [BULK] window.
Cursor to the desired data type using the ARROW buttons, and press the
ENTER button. The selected button is shown as inverse video.
Press the ARROW button to move the cursor to the right. Rotate the
JogDial to display the desired data name, and press the ENTER button.
To receive or send data collectively, cursor to the button, and
press the ENTER button. This setting permits simultaneous sending or
receiving of the nine kinds of data shown on the window.
To receive data from another DA7, cursor to the button. To
send data from the DA7, cursor to the button.
Press the ENTER button to receive or send data.
If the button is pressed, the DA7 sends a request message for
MIDI bulk dump to the device, which sends the requested data to the
DA7. Then operate the device to send data, if any device other than
another DA7 is connected.
Or,
If the button is pressed, the DA7 sends the data specified by
the above operation to the device.
OFF
ON
OFF
ON
1
2
3
4
5
6
7
8