Filter
Top Products
Chapter 3
DA7 Users’ Guide
3
-
13
3
Quick Start
How to Connect the Analog Inserts (1-16)
Plug in the effects processor
_
Plug the send into the input of the effects
device and plug the return into the output of the effects device.
Raise the source fader on the DA7. Adjust the mix balance from the
effects device. For further information see page Appendix E-2, Cables
and Connections.
Digital Send and Return
Connect the output
_
Using an XLR cable, connect the REC OUT of the
DIGITAL IN/OUT on the Rear Panel of the DA7 to the recording device.
Connect the input
_
Using an XLR cable, connect the output from the
digital recording device to the 2TR A IN / INPUT 15, 16 DIGITAL
IN/OUT of the DA7.
Send the signal out
_
This output is the same as the MASTER L/R
output.
Listen to tape playback
_
Optionally, you may return 2 TR IN A as
INPUT 15, 16 on the mixer. To do this, go to the [D-I/O>INPUT SET]
window, and select 2 TR IN A to INPUT 15, 16.
Or,
Connect the output
_
Connect the AUX 1/2 SEND to the input of a
digital recorder, or to the input of a digital effects device.
Connect the input
_
Connect the stereo outputs of the digital device to
the AUX 1/2 RETURN.
1
2
1
2
3
4
1
2