Filter
Top Products
Chapter 11
DA7 Users’ Guide
11
-
19
11
MIDI
Selecting [COMMAND MODE]
Cursor to the [COMMAND MODE] area. Select either or
[CONTROL CHANGE]. Select the control change number with the
JogDial. In the message can be edited.
Edit the Control Change
Cursor to the button, and press the ENTER button. The [CTRL
CHG NO] area appears.
Cursor to the [CTRL CHG NO] area, and rotate the JogDial to select the
control change number from 000 – 119.
Edit of User Definition Data
The [SW STS] area works when using the JogDial. Switching the button
or sets transmission data rows separately with the objective
operator and .
For data row input parts, cursor to the data by one byte and select a value
using the JogDial. At that time, the cursor can move to both the sector where
the data exists and the next sector of the last data.
Selectable data is 00H – F8H, FAH – FFH, K, F, or E.
The K transmits the value the Knob indicates. The F transmits the value the
Fader indicates, while E means End of message.
When you have finished editing the MIDI REMOTE information, cursor to the
button, and press the ENTER button. If you decide not to keep your
changes, cursor to the button, and press the ENTER button.
ON
OFF
ON
OFF
1
2