Filter
Top Products
Chapter 14
DA7 Users’ Guide
14
-
22
14
Automation
Cursor to the [ENABLE] button in the [AUTOMATION] area, and press
the ENTER button.
Cursor to the [REC] button in the [AUTOMATION] area, and press the
ENTER button to start or stop recording.
Press the SELECT LED buttons of the Channel Strips to be engaged
into a MIX sequence. The engaged SELECT LED buttons (orange) and
SEL/MAN (red) will light. Press it again to cancel. These buttons are
operable during playing back or recording of a MIX sequence.
Now, you are ready to start automation recording of your mix.
Start the play-back of the audio master device, such as MTR or Hard Disk
Recorder in your system, from the beginning where you will start
recording a MIX. Make sure that the DA7 is receiving the timecode
properly from this device.
You can now make any changes to the parameters you have chosen for
any selected channel or channels and they will be recorded by the
Automation system.
Don't forget about the AUTOMATION/AUX button shortcut on
the Top Panel to enable Automation. You may find it is a faster
way to perform this function.
If the MMC mode on the CURSOR/MMC button is active, don't
forget about the [CURSOR MODE/REC] shortcut on the Top
Panel to start or stop recording.
The remote switch on the Rear Panel of the DA7 can be used to
“punch-in” or “punch-out” of a mix.
7
8
9
10
Pressing the SHIFT (#0) button and SELECT LED button of the
desired channel simultaneously enables you to change the
channel for [EQUALIZER] or [DYNAMICS/DELAY].