Filter
Top Products
[TIME] Field
In the [AUTO MOVE] area you can set the automated move time. Cursor
to the field, and rotate the JogDial to set a time value. The [TIME] field
has a duration range of 0.0 sec to 30.0 sec.
[START]
This button starts and stops the automated move time. Press
ENTER
to
toggle the setting.
In
AUTO MOVE
you can start up to 8 channels. A warning message
appears on the
LCD
if you try to start the 9th channel.
BUS Outputs
Buses 1 through 6 can be toggled on and off by moving the cursor to a soft
knob and pressing the ENTER button. The following chart shows the DA7
surround knobs and their correlating soft knobs.
Left front . . . . .[L/BUS 1] . . . .Q
. . . . . . . EQUALIZER section
Right front . . . .[R/BUS 2] . . . .
. . . . . . . . . DYNAMICS/DELAY section
Center . . . . . . .[C/BUS 3] . . . .PAN
. . . . . .
PAN/ASSIGN section
Sub . . . . . . . . .[SB/BUS 4] . . .GAIN
. . . .
EQUALIZER section
Left rear . . . . .[SL/BUS 5] . . .FREQ
. . .
EQUALIZER section
Right rear . . . .[SR/BUS 6] . . .
. . . . . . . . .
DYNAMICS/DELAY section
The bus assignment for any selected channel can be seen in the [ASSIGN]
area of the [CHANNEL] window.
Please refere to Chapter 16, Utility and Solo Monitor, page 16-3 for the
phisycal surround monitor connections.
SR
SL
SUB
C
R
L
Chapter 8
DA7 Users’ Guide
8
-
10
8
Pan/Assign
Surround
To monitor surround sound, turn ON and assign the buses as
surround sound in the [SURROUND MONITOR] area of the
[SOLO/MONITOR] window.
See Chapter 16, Utility and Solo Monitor for more details.