Filter
Top Products
Chapter 9
DA7 Users’ Guide
9
-
8
9
Dynamics/
Delay
Button
When the button is on, it will appear as inverse video, and change the
scale of the dynamics graph from OL to -100, to OL to -50. Any changes to the
dynamics settings will appear in the graph area beneath the button.
[GAIN REDUCTION] Area
When a selected signal is input in the [COMP+GATE] mode, gain reduction
for that input signal is graphically displayed on the [GR] Meter. The amount
of gain is referenced by twin arrows on either side of the gain bar scale,
which slide up and down in relation to the amount of gain reduction. The
reference is connected to the [GAIN] knob. Adjust the gain level with the
[GAIN] knob. The scale will show gain reduction from +12dB to 0dB, the
same as the range of the [GAIN] knob.
[GATE] mode
[THL] Area
Threshold sets the level at which the gate opens and closes. Signals below
the threshold point will close the gate and prevent the signal from passing.
Signals above the threshold point will pass through the gate. Values for the
threshold are -80dB to -15dB.
[ATTACK] Area
The attack time is how long it takes for the gate to kick in after the signal has
triggered it. A short attack of around 10 ms is a good starting point. Values
for attack time are from 0 ms to 250 ms.
GAIN REDUCTION Area