Filter
Top Products
Compressor Operations
Display the [DYNAMICS] window by pressing the knob in the
DYNAMICS/DELAY section. Or, cursor to the [DYN] area graph in the
[CHANNEL] window, and press the ENTER button to display the
[DYNAMICS] window. Or, when the [AUTO DISP CHANGE] selection
in the [UTILITY>CONFIG] window is , pressing an LED button or
adjusting a knob in the DYNAMICS section will automatically display
the [DYNAMICS] window.
Press the SELECT button for the channel you want to edit. The
[DYNAMICS] window updates to the selected channel.
Turn the dynamics on (green) by pressing the DYNAMICS ON LED
button on the Top Panel, or the [ON] button in the [DYNAMICS]
window.
Cursor to the button in the [FUNCTION] area, and press the
ENTER button to engage the compressor. When the button is
pressed, is disabled.
Cursor to the [STEREO LINK], and select a mode by using the JogDial
when the channel is in stereo pair.
Select a parameter you want to adjust by moving the cursor through the
window, or by using the PARAMETER SELECT button on the Top
Panel.
Adjust the parameter by rotating the JogDial, or use the knob for
threshold, attack, and delay, and the knob for ratio, release, and
gain. The parameter title will then be indicated in reverse video. Use the
JogDial and knobs to select the parameter independently. The adjusted
parameter is graphically displayed on the screen.
When a signal is input, gain reduction for the input signal is indicated in
the [GR] meter, and the reference point of the [GR] meter is highlighted.
The reference is connected to the [GAIN] parameter. After adjusting the
compressor, adjust the level so that the peak of the reduction is close to
0 dB on the [GR] meter in the [DYNAMICS] window.
ON
Chapter 9
DA7 Users’ Guide
9
-
11
9
Dynamics/
Delay
1
5
6
7
8
4
2
3