Filter
Top Products
Button
Select a parameter to be registered in the [CONTROL CHANGE TABLE]
by rotating the JogDial.
Button
Select a channel to be registered in the [CONTROL CHANGE TABLE]
by rotating the JogDial.
[Assign ] Element
This area indicates status. The parameter and channel are registered to
the selected table by pressing the ENTER button. At that time, the
[Assign ] is highlighted and shows the selection. If a combination of
the selected parameter and channel is not acceptable, the arrow is
distorted, showing that the parameter and channel cannot be registered.
Button
Initialize the table. Cursor to the button, and press the
ENTER button.
Setting of Registration
Press the MIDI button on the Top Panel to display the [MIDI>CTRL
ASGN] window on the LCD.
Cursor to the [CONTROL CHANGE TABLE] area. Turn the JogDial to
move the cursor to the line to be rewritten.
Press the up ARROW button to move the cursor to [PARAMETER] in
the top part of the window. Rotate the JogDial to display the desired
parameter.
Press the right ARROW button to move the cursor to the field below
[CHANNEL] near the top of the window, and rotate the JogDial to
display the desired channel.
Press the ENTER button. The [Assign ] element is shown inversely
for a moment. The selected item is written on the specified line.
Chapter 11
DA7 Users’ Guide
11
-
9
11
MIDI
1
2
3
4
5