Filter
Top Products
136
(2) If is displayed in "Network Status"
(a) If the system does not contain a switching hub
Ring topology is configured even though the loopback function is disabled.
Take the following measures:
• When not using the loopback function
Disconnect an Ethernet cable connected to any station on the network (either PORT1 or PORT2).
The network topology will become a line topology and data link will start.
• When using the loopback function
Enable the loopback function and rewrite the network parameters to the safety CPU module.
( Page 121, Section 8.6 )
Information
Confirmation/
Set
button
Displays event history of a network. ( Page 140, Section 9.5)
button
Temporarily cancels a reservation for a slave station or reserves the slave station again.
( Page 142, Section 9.6)
button
Sets a slave station as a temporary error invalid station. ( Page 146, Section 9.7)
Selected
Station
Operation
button
Displays the System Monitor window. ( Page 235, Section 12.2)
button
Performs remote operation (RUN, STOP, and RESET operations) to the safety CPU module.
( Page 151, Section 9.8)
Item Description