Filter
Top Products
78
*1 This parameter needs to be set for standard communication (needs not to be set for safety communication).
Always set parameters. Failure to do so will cause "NETWORK PARAMETER ERROR" in the safety CPU module.
Network Configuration
Setting
Station No.
Page 81, Section
7.3
Station Type
RX/RY Setting
*1
RWw/RWr Setting
*1
Reserved/Error Invalid Station
Alias
Comment
Supplementary
Setting
Link Scan Mode
Setting
Loopback Function
Setting
Block Data
Assurance per
Station
Network Operation
Setting
Parameter Name
Page 85, Section
7.4
Data Link Faulty Station Setting
Output Setting During CPU STOP
Refresh parameters
Page 86, Section
7.5
Safety Communication
Setting
Communication Target Station No.
Page 90, Section
7.6
Open Method
Transmission Interval Monitoring Time
Safety Refresh Monitoring Time
Safety Data Transfer Device Setting
Routing parameters
Page 92, Section
7.7
Item
Setting
Reference
Master
station
(safety
station)
Local
station
(safety
station)
Local
station
(standard
station)
2
3
4
5
6