Filter
Top Products
194
10.8 JP/GP.REQ (Reading/Writing Clock Data)
This instruction reads and writes the clock data of the programmable controller on another station.
(1) Setting data
Setting data
Available devices
Internal device (System, user) Constant
Others
Bit Word K, H
(S1)
(S2)
(D1)
(D2)
Setting data Description Set by Data type
Jn
Own station's network No. (1 to 239, 254)
254: Network specified in Valid Module During Other Station Access
User
16-bit binary
Un
Start I/O number of the master/local module of own station
(00 to 3E
H
: Upper 2 digits of the I/O number expressed in 3 digits)
(S1)
Start device of the own station where control data is stored
( Page 195, Section 10.8 (1) (a))
Device name(S2)
Start device of the own station where receive data is stored
( Page 198, Section 10.8 (1) (b))
(D1)
Start device of the own station where response data is stored
( Page 199, Section 10.8 (1) (c))
System
(D2)
Device of the own station, which is turned on for 1 scan upon
completion of the instruction
(D2)+1 is turned on as well when the instruction fails.
Bit
JP.REQ
Start contact
GP.REQ
Start contact
JP.REQ Jn
GP.REQ Un
(S1) (D1) (D2)(S2)
(S1) (D1) (D2)(S2)