Filter
Top Products
74
6.4.2 Cable test
Cable test checks if the Ethernet cables are properly connected.
Only the Ethernet cable connected to the PORT1 or PORT2 of the target station is tested. For the whole network
status, perform the loop test. ( Page 67, Section 6.4.1)
1. Connect GX Developer to the safety CPU
module.
2. Open the "Cable Test" window.
[Diagnostics] [CC IE Field diagnostics]
button
3. Enter a station number and click the
button to operate the test. If an error occurs, take
corrective actions according to the error
message.
Station No. 0 Station No. 1 Station No. 2 Station No. 3