Filter
Top Products
217
CHAPTER 11 PROGRAMMING
11
11.2 Communication Example of when Safety Stations and a Standard Station are Used
11.2.3 Local station (safety station) settings
5. Configure safety communication setting.
Set devices for the local stations (safety stations) of station No.1 and station No.2 so that they do not
overlap with ones set for refresh parameters.
Project data list [Parameter] [Network param] [Ethernet/CC IE/MELSECNET]
button
6. Write the parameters to the safety CPU modules on the local stations (safety stations), and either
reset or power them off and on.
[Online] [Write to PLC]
In this example, default values were used for parameters that are not shown above. For parameter setting, refer to the
parameter explanation chapter. ( Page 77, CHAPTER 7)
Station No. 1
Station No. 2
or powering off on