Filter
Top Products
187
CHAPTER 10 DEDICATED INSTRUCTIONS
10
10.7 JP/GP.SWRITE (Writing Data to the Programmable Controller on Another Station)
10.7 JP/GP.SWRITE (Writing Data to the Programmable
Controller on Another Station)
This instruction writes data to the device of the programmable controller on another station. (In units of words)
With the SWRITE instruction, the device of the other station is turned on when data writing is completed. Data writing
with the SREAD instruction can be confirmed by this.
*1 T, C, D, W, ST, SD, and SW can be used.
When specifying SD/SW, it can be written in the range that the user can set.
For details on SD/SW, refer to the following.
Manuals for the CPU module and network module of the target station
*2 For the SWRITE instruction, the write notification device (D3) can be omitted in the programming.
However, the operation is the same as the WRITE instruction.
The SWRITE instruction can operate differently depending on whether the write notification device (D3) is omitted or not.
*3 When the target station is a Basic model QCPU, the data set in the write notification device (D3) is ignored. (Operation is
the same as the WRITE instruction.)
Setting data
Available devices
Internal device (System, user) Constant
Others
Bit Word K, H
(S1)
(S2)
(D1)
*1
(D2)
(D3)
JP.SWRITE
Start contact
GP.SWRITE
Start contact
JP.SWRITE
Jn
GP.SWRITE
Un
or
""
or
""
*2*3
*2*3
(S1)
(D1)
(D1)
(D1)
(D1)
(S2) (D2)
(S1) (S2) (D2)
(D3)
(D3)