Filter
Top Products
68
(a) Preparing for a loop test
After wiring, set the local stations (safety stations) to online mode before executing the loop test.
Remark
For slave stations other than the local station where the master/local module is mounted, also set their mode to online. For
the setting method of slave stations, refer to the manual of the slave station used.
1. Connect GX Developer to the CPU module.
2. Set the local stations (safety stations) to online
mode by GX Developer.
3. Reset the slave stations or power off and on to
set the mode to online.
Master station
(safety station)
Local station (safety station)
Select "Online."
In the case of a local station (safety station)
Select
"CC IE Field (Local
station [Safety])".
Ex.