Filter
Top Products
Operating Instructions Teledyne API - Model T200H/T200M Operation Manual
128
4.13.1. ACCESSING THE DIAGNOSTIC FEATURES
To access the DIAG functions press the following keys:
SETUP X.X ENTER DIAG PASS: 818
8 1 8 ENTR EXIT
SETUP X.X
PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SETUP X.X
SECONDARY SETUP MENU
COMM VARS DIA
G
EXIT
From this point
forward, EXIT returns
to the
SECONDARY
SETUP MENU
DIAG SIGNAL I / O
NEXT ENTR EXIT
DIA
G
ANALOG OUTPUT
PREV NEXT ENTR EXIT
DIAG
A
NALOG I / O CONFIGURATION
PREV NEXT ENTR EXIT
DIAG DISPLAY SEQUENCE CONFIG.
PREV NEXT ENTR EXIT
DIAG ELECTRICAL TEST
PREV NEXT ENTR EXIT
DIAG OZONE GEN OVERRIDE
PREV NEXT ENTR EXIT
EXIT returns
to the main
SAMPLE
display
DIAG OPTIC TEST
PREV NEXT ENTR EXIT
DIAG FLOW CALIBRATION
PREV NEXT ENTR EXIT
SAMPLE A1:NXCNC1=100PPM NOX=XXX.X
< TST TST > CAL SETUP
At this point EXIT
returns
to the PRIMARY
SETUP MENU
4.13.2. SIGNAL I/O
The signal I/O diagnostic mode allows to review and change the digital and analog
input/output functions of the analyzer. See Appendix A-4 for a complete list of the
parameters available for review under this menu.
Note Changes to signal I/O settings will remain in effect only until the signal I/O
menu is exited. Exceptions are the ozone generator override and the flow
sensor calibration, which remain as entered when exiting.
07270B DCN6512